LEMON Manuals: Even more car manuals for everyone
Home >> Toyota >> 2022 >> Avalon XLE >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 55 (Engine Lubrication System (Service Information) [A25A-FXS]) >> Oil Pressure And Temperature Sensor >> Removal [08/2019 - ] >> Procedure

Removal [08/2019 - ]: Procedure

WARNING: This page is about a different variant/trim than selected.
  1. REMOVE FRONT WHEEL OPENING EXTENSION PAD LH 

    Refer to PROCEDURE - Step 7 [04/2018 - 08/2021] , or refer to PROCEDURE - Step 7 [08/2021 - ]

  2. REMOVE FRONT WHEEL OPENING EXTENSION PAD RH 

    Refer to PROCEDURE - Step 8 [04/2018 - 08/2021] , or refer to PROCEDURE - Step 8 [08/2021 - ]

  3. REMOVE NO. 1 ENGINE UNDER COVER 

    Refer to PROCEDURE - Step 9 [04/2018 - 08/2021] , or refer to PROCEDURE - Step 9 [08/2021 - ]

  4. REMOVE NO. 2 ENGINE UNDER COVER ASSEMBLY 

    Refer to PROCEDURE - Step 10 [04/2018 - 08/2021] , or refer to PROCEDURE - Step 10 [08/2021 - ]

  5. REMOVE OIL PRESSURE AND TEMPERATURE SENSOR 
    1. Disconnect the oil pressure and temperature sensor connector.
    2. Using a 24 mm deep socket wrench, remove the oil pressure and temperature sensor.
      GTY932506Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
      NOTE:

      If the oil pressure and temperature sensor is dropped or subjected to a strong impact, replace it with a new one.

scientia non olet · About LEMON Manuals