LEMON Manuals: Even more car manuals for everyone
Home >> Toyota >> 2022 >> Avalon XLE >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 52 (Engine Control System - Diagnostic Codes [A25A-FXS] (P0190-P0400)) >> SFI System >> DTC P0335-2A: Crankshaft Position Sensor "A" Signal Stuck in Range; DTC P0335-31: Crankshaft Position Sensor "A" No Signal [04/2018 -] >> Typical Enabling Conditions

Typical Enabling Conditions

WARNING: This page is about a different variant/trim than selected.
ALL

Both of the following conditions are met -
Hybrid control module judge Engine running
Lost communication with hybrid vehicle control ECU assembly (U0293) Not detected
P0335 (CASE 1)

All of the following conditions are met -
Auxiliary battery voltage Higher than 6 V
Crankshaft position sensor voltage 0.3 to 4.7 V
Power switch On (IG)
P0335 (CASE 2)

All of the following conditions are met -
Auxiliary battery voltage Higher than 6 V
Crankshaft position sensor voltage 0.3 to 4.7 V
Starter Off
Engine speed (Top dead center) 600 rpm or higher
Engine speed (30°CA) 600 rpm or higher