Caution / Notice / Hint
WARNING: This page is about a different variant/trim than selected.
NOTE:
- When replacing the combination meter assembly, always replace it with a new one. If a combination meter assembly which was installed to another vehicle is used, the information stored in it will not match the information from the vehicle and a DTC may be stored.
- Before starting the following inspection, inspect the speedometer and check that the tire size and air pressure are as specified.
Tire size and air pressure: Refer to INSPECTION [04/2018 - 08/2020] , or refer to INSPECTION [08/2020 - ]
Speedometer: Refer to ON-VEHICLE INSPECTION [04/2018 - ]