Odo/Trip Switch Malfunction [04/2018 - ]: Procedure

1. Connect the Techstream to the DLC3.
2. Turn the power switch on (IG).
3. Turn the Techstream on.
4. Enter the following menus: Body Electrical / Combination Meter / Data List.
5. Read the Data List according to the display on the Techstream.

   Body Electrical > Combination Meter > Data List 

   Tester Display	Measurement Item	Range	Normal Condition	Diagnostic Note
   ODO/TRIP Change Switch	ODO/TRIP switch (Trip switch)	OFF or ON	OFF: Switch released ON: Switch pushed	-

   Body Electrical > Combination Meter > Data List 

   Tester Display
   ODO/TRIP Change Switch

   OK

   ODO/TRIP switch (trip switch) condition displayed on the Techstream changes with the actual switch operation.

   Result

   Proceed to
   OK
   NG

Result: 

OK 

REPLACE COMBINATION METER ASSEMBLY. Refer to  REMOVAL [04/2018 - 08/2020]  , or refer to  REMOVAL [08/2020 - 08/2021]  , or refer to  REMOVAL [08/2021 - ] 

Result: 

NG 

See step  2

1. Remove the trip switch.

   Refer to REMOVAL [04/2018 - ]

2. Inspect the trip switch.

   Refer to INSPECTION [04/2018 - ]

   Result

   Proceed to
   OK
   NG

Result: 

NG 

REPLACE TRIP SWITCH. Refer to  REMOVAL [04/2018 - ] 

Result: 

OK 

See step  3

1. Disconnect the G15 combination meter assembly connector.
2. Measure the resistance according to the value(s) in the table below.

   Standard Resistance

   Tester Connection	Condition	Specified Condition
   G80-3 (A/B) - G15-1 (ODO)	Always	Below 1 Ω
   G80-1 (E) - G15-5 (SW3)	Always	Below 1 Ω
   G80-3 (A/B) or G15-1 (ODO) - Body ground	Always	10 kΩ or higher

   Result

   Proceed to
   OK
   NG

Result: 

OK 

REPLACE COMBINATION METER ASSEMBLY. Refer to  REMOVAL [04/2018 - 08/2020]  , or refer to  REMOVAL [08/2020 - 08/2021]  , or refer to  REMOVAL [08/2021 - ] 

Result: 

NG 

REPAIR OR REPLACE HARNESS OR CONNECTOR