LEMON Manuals: Even more car manuals for everyone
Home >> Toyota >> 2022 >> Avalon XLE >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 40 (Hybrid Transmission (Service Information) [P710]) >> Motor Cable >> Installation [04/2018 - ] >> Procedure

Installation [04/2018 - ]: Procedure

WARNING: This page is about a different variant/trim than selected.
  1. INSTALL MOTOR CABLE 
    WARNING:

    Be sure to wear insulated gloves.

    1. Using an insulated tool, install the motor cable to the hybrid vehicle transaxle assembly with the 6 bolts.

      Torque: 10 N*m (102 kgf*cm, 7 ft.*lbf) 

      NOTE:
      • Keep the motor cable terminals and their installation area free from foreign matter, water, etc.
      • Do not touch the waterproof seal or terminals of the motor cable.
    2. Engage the 2 claws to install a new terminal cap to the hybrid vehicle transaxle assembly.
      NOTE:
      • Keep the terminal cap and its installation area free from foreign matter, water, etc.
      • Do not pinch the O-ring.
      • Check that the terminal cap is securely installed.
    3. Temporarily install the connector cover to the hybrid vehicle transaxle assembly with the 2 bolts.
    4. Tighten the 2 bolts to install the connector cover.

      Torque: 10 N*m (102 kgf*cm, 7 ft.*lbf) 

  2. INSTALL INVERTER WITH CONVERTER ASSEMBLY 

    Refer to INSTALLATION [04/2018 - ]

scientia non olet · About LEMON Manuals