Caution / Notice / Hint

WARNING: This page is about a different variant/trim than selected.

NOTE:

First check the CAN communication system by following How to Proceed with Troubleshooting. After checking that there are no malfunctions in the CAN communication system, proceed with troubleshooting.
Refer to HOW TO PROCEED WITH TROUBLESHOOTING [04/2018 -]
Before replacing the hybrid vehicle control ECU, refer to Registration.
Refer to REGISTRATION [04/2018 - 08/2020] , or refer to REGISTRATION [08/2020 -]
After the skid control ECU (brake booster with master cylinder assembly) is replaced, perform the yaw rate and acceleration sensor zero point calibration.
Refer to CALIBRATION [04/2018 - 08/2021]