Caution / Notice / Hint
WARNING: This page is about a different variant/trim than selected.
NOTE:
- When replacing the millimeter wave radar sensor assembly, make sure to replace it with a new one. If a device which was installed to another vehicle is used, the information stored in the millimeter wave radar sensor assembly will not match the information from the vehicle, and as a result, a DTC may be stored.
- When the millimeter wave radar sensor assembly is replaced with a new one, adjustment of the radar sensor beam axis must be performed.
Refer to ADJUSTMENT [04/2018 - 08/2020] , or refer to ADJUSTMENT [08/2020 - 08/2021]