Cruise SET Indicator Light Circuit [08/2021 -]: Procedure
WARNING: This page is about a different variant/trim than selected.
- PERFORM ACTIVE TEST USING TECHSTREAM (Combination Meter)
- Perform the Active Test according to the display on the Techstream.
Body Electrical > Combination Meter > Active Test
Tester Display Measurement Item Control Range Diagnostic Note Multi Display All (White) Multi-information display (White display) ON Confirm that the vehicle is stopped with the power switch on (IG). Body Electrical > Combination Meter > Active Test
Tester Display Multi Display All (White) Result
Result Proceed to The multi-information display in the combination meter assembly turns on according to the operation of the Active Test A The multi-information display in the combination meter assembly does not turn on according to the operation of the Active Test B
Result:
B
GO TO METER / GAUGE SYSTEM. Refer to HOW TO PROCEED WITH TROUBLESHOOTING [04/2018 -]
Result:
A
See step 2
- Perform the Active Test according to the display on the Techstream.
- READ VALUE USING TECHSTREAM (Radar Cruise1)
- Turn the dynamic radar cruise control system on using the cruise control main switch.
- Drive at a speed between approximately 30 km/h (20 mph) and 180 km/h (110 mph).
- Read the Data List according to the display on the Techstream.
Powertrain > Radar Cruise1 > Data List
Tester Display Measurement Item Range Normal Condition Diagnostic Note -SET Switch -SET switch status ON or OFF ON: -SET switch on
OFF: -SET switch off- Powertrain > Radar Cruise1 > Data List
Tester Display -SET Switch Result
Result Proceed to The cruise SET indicator illuminates and turns off according to the operation of the cruise control main switch (-SET) A The cruise SET indicator does not illuminate but the Data List item -SET Switch changes according to the operation of the cruise control main switch (-SET) B The cruise SET indicator does not illuminate and the Data List item -SET Switch does not change according to the operation of the cruise control main switch (-SET) C
Result:
A
PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE. Refer to PROBLEM SYMPTOMS TABLE [08/2021 -]
Result:
B
REPLACE COMBINATION METER ASSEMBLY. Refer to REMOVAL [08/2021 -]
Result:
C
REPLACE HYBRID VEHICLE CONTROL ECU. Refer to REMOVAL [08/2021 -]