Installation [04/2018 -]: Procedure
WARNING: This page is about a different variant/trim than selected.
- INSTALL E.F.I. VACUUM SENSOR ASSEMBLY (MANIFOLD ABSOLUTE PRESSURE SENSOR)
- Using an 8 mm socket wrench, install the E.F.I. vacuum sensor assembly (manifold absolute pressure sensor) to the intake manifold with the bolt.
Torque: 5.0 N*m (51 kgf*cm, 44 in.*lbf)
- Connect the vacuum hose to the E.F.I. vacuum sensor assembly (manifold absolute pressure sensor).
- Connect the E.F.I. vacuum sensor assembly (manifold absolute pressure sensor) connector.
- Using an 8 mm socket wrench, install the E.F.I. vacuum sensor assembly (manifold absolute pressure sensor) to the intake manifold with the bolt.