Removal [04/2018 -]: Procedure
WARNING: This page is about a different variant/trim than selected.
- REMOVE FUEL VAPOR CONTAINMENT VALVE (FUEL TANK SOLENOID MAIN VALVE ASSEMBLY)
- Disconnect the fuel vapor containment valve (fuel tank solenoid main valve assembly) connector.
- Disconnect the fuel tank vent hose sub-assembly from the fuel vapor containment valve (fuel tank solenoid main valve assembly).
*a Retainer *b Tab *c Tube Connector *d O-ring *e Pipe (Fuel Vapor Containment Valve (Fuel Tank Solenoid Main Valve Assembly)) - - Pinch Pull Pull off - - NOTE:- Remove any dirt or foreign matter on the tube connectors before performing this work.
- Do not allow any scratches or foreign matter to get on the parts when disconnecting them as the tube connector has an O-ring that seals the pipe (fuel vapor containment valve (fuel tank solenoid main valve assembly)).
- Perform this work by hand. Do not use any tools.
- Do not forcibly bend, twist or turn the fuel tank vent hose sub-assembly.
- Protect the disconnected parts by covering them with plastic bags after disconnecting the fuel tank vent hose sub-assembly.
- If the tube connector and pipe (fuel vapor containment valve (fuel tank solenoid main valve assembly)) are stuck, push and pull to release them.
HINT:
Do not remove the retainer.
- Pinch the tabs of the retainer to disengage the lock claws and pull it down.
- Pull off the fuel tank vent hose sub-assembly.
- Disconnect the fuel tank vent hose from the fuel vapor containment valve (fuel tank solenoid main valve assembly).
*a Retainer *b Tab *c Tube Connector *d O-ring *e Pipe (Fuel Vapor Containment Valve (Fuel Tank Solenoid Main Valve Assembly)) - - Pinch Pull Pull off - - NOTE:- Remove any dirt or foreign matter on the tube connectors before performing this work.
- Do not allow any scratches or foreign matter to get on the parts when disconnecting them as the tube connector has an O-ring that seals the pipe (fuel vapor containment valve (fuel tank solenoid main valve assembly)).
- Perform this work by hand. Do not use any tools.
- Do not forcibly bend, twist or turn the fuel tank vent hose.
- Protect the disconnected parts by covering them with plastic bags after disconnecting the fuel tank vent hose.
- If the tube connector and pipe (fuel vapor containment valve (fuel tank solenoid main valve assembly)) are stuck, push and pull to release them.
HINT:
Do not remove the retainer.
- Pinch the tabs of the retainer to disengage the lock claws and pull it down.
- Pull off the fuel tank vent hose.
- Remove the 2 nuts and fuel vapor containment valve (fuel tank solenoid main valve assembly) from the vehicle body.
- Disconnect the fuel vapor containment valve (fuel tank solenoid main valve assembly) connector.