Removal [04/2018 - 08/2020]: Procedure

WARNING: This page is about a different variant/trim than selected.

REMOVE LUGGAGE TRIM SERVICE HOLE COVER
Refer to PROCEDURE - Step 2 [04/2018 - 08/2019] , or refer to PROCEDURE - Step 2 [08/2019 - 08/2021]
DISCONNECT CABLE FROM NEGATIVE AUXILIARY BATTERY TERMINAL
Refer to PROCEDURE - Step 3 [04/2018 - 08/2019] , or refer to PROCEDURE - Step 3 [08/2019 - 08/2021]

REMOVE ECM

Rotate the 2 levers while pushing the locks, and disconnect the 2 ECM connectors.

Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

NOTE:

After disconnecting the ECM connectors, make sure that dirt, water and other foreign matter does not contact the connecting parts of the ECM connectors.

Remove the bolt and separate the engine wire from the No. 2 ECM bracket.
Disengage the clamp.

Remove the 2 nuts and ECM.

Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

NOTE:

If the ECM has been struck or dropped, replace it.

REMOVE NO. 1 ECM BRACKET

Remove the 2 screws and No. 1 ECM bracket from the ECM.

REMOVE NO. 2 ECM BRACKET

Remove the 2 screws and No. 2 ECM bracket from the ECM.