Inspection [04/2018 - ]: Procedure
WARNING: This page is about a different variant/trim than selected.
- INSPECT AIR FUEL RATIO SENSOR
- Measure the resistance according to the value(s) in the table below.
*a Component without harness connected
(Air Fuel Ratio Sensor)Standard Resistance
Tester Connection Condition Specified Condition 1 (HA1B) - 2 (+B) 20°C (68°F) 2 to 6 Ω 1 (HA1B) - 4 (A1B-) Always 10 kΩ or higher If the result is not as specified, replace the air fuel ratio sensor.
- Measure the resistance according to the value(s) in the table below.