Removal [04/2018 - 08/2021]: Caution/Notice/Hint
WARNING: This page is about a different variant/trim than selected.
The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are removed and installed, or replaced during fuel pump control ECU removal/installation are shown below.
NECESSARY PROCEDURES AFTER PARTS REMOVED/INSTALLED/REPLACED
| Replaced Part or Performed Procedure | Necessary Procedure | Effect/Inoperative Function when Necessary Procedure not Performed | Link |
|---|---|---|---|
| Auxiliary battery terminal is disconnected/reconnected | Perform steering sensor zero point calibration | Lane Departure Alert System (w/ Steering Control) | Refer to INITIALIZATION [04/2018 - 08/2021] |
| Pre-collision System | |||
| Intelligent Clearance Sonar System* | |||
| Lighting System (for HV Model with Cornering Light) | |||
| Memorize steering angle neutral point | Parking Assist Monitor System | Refer to INITIALIZATION [04/2018 - ] | |
| Panoramic View Monitor System | Refer to INITIALIZATION [04/2018 - ] |
*: When performing learning using the Techstream.