Installation [04/2018 - ]: Procedure

1. for Type A:
   1. Apply gasoline to 2 new O-rings. Then install the O-rings to the fuel main valve assembly.
   2. Install the fuel main valve assembly to the fuel suction tube with pump and gauge assembly.
      NOTE:

      Make sure that the O-rings are not cut or pinched during installation.

   3. Install the clip to the fuel suction tube with pump and gauge assembly.
2. for Type B:
   1. Apply gasoline to a new O-ring. Then install the O-ring to the fuel main valve assembly.
      NOTE:

      Make sure that there is no clearance between the fuel main valve assembly and mesh.

      Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

      *1	Fuel Main Valve Assembly
      *a	Mesh
      *b	Mini-clip
      *c	No Clearance

   2. Install the fuel main valve assembly to the fuel suction tube with pump and gauge assembly.
      NOTE:

      Make sure that the O-ring is not cut or pinched during installation.

   3. Engage the 2 claws to install the fuel pressure regulator holder to the fuel suction tube with pump and gauge assembly.

Refer to INSTALLATION [04/2018 - ]