Installation [04/2018 - ]: Procedure

HINT: 

Perform "Inspection After Repair" after replacing the fuel pressure sensor.

Refer to INITIALIZATION [04/2018 - 08/2019] , or refer to INITIALIZATION [08/2019 - 08/2021] , or refer to INITIALIZATION [08/2021 - ]

1. Temporarily install a new fuel pressure sensor to the fuel delivery pipe as shown in the illustration.

   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

   *a	Cutout (Fuel Delivery Pipe)
   *b	Cutout (Fuel Pressure Sensor)

   NOTE:

   Make sure that the cutout of the fuel delivery pipe is aligned with the cutout of the fuel pressure sensor.

2. Temporarily install the No. 1 fuel pressure sensor holder to the fuel delivery pipe as shown in the illustration.

   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

   *a	Cutout (Fuel Pressure Sensor)
   *b	Cutout (No. 1 Fuel Pressure Sensor Holder)

   NOTE:

   Make sure that the cutout of the fuel pressure sensor is aligned with the cutout of the No. 1 fuel pressure sensor holder.

3. Using an 8 mm socket wrench, install the 2 bolts.

   Torque: 10 N*m (102 kgf*cm, 7 ft.*lbf) 

4. Connect the fuel pressure sensor connector.

Refer to INSTALLATION [04/2018 - 08/2021] , or refer to INSTALLATION [08/2021 - ]

Refer to PROCEDURE - Step 2

Refer to PROCEDURE - Step 3

Refer to PROCEDURE - Step 1

1. Perform "Inspection After Repair" after replacing the fuel pressure sensor.

   Refer to INITIALIZATION [04/2018 - 08/2019] , or refer to INITIALIZATION [08/2019 - 08/2021] , or refer to INITIALIZATION [08/2021 - ]