Freeze Frame Data [04/2018 -]
WARNING: This page is about a different variant/trim than selected.
- CHECK FREEZE FRAME DATA
- Connect the Techstream to the DLC3.
- Turn the power switch on (IG).
- Turn the Techstream on.
- Enter the following menus: Body Electrical / Navigation System / Trouble Codes.
Body Electrical > Navigation System > Trouble Codes
- Select a DTC to display its freeze frame data.
- LIST OF FREEZE FRAME DATA
Body Electrical > Navigation System
Tester Display Measurement Item Range Normal Condition Diagnostic Note Battery Voltage Auxiliary battery voltage Min.: 0 V, Max.: 24 V 11 to 15.5 V - Active Dimmer Active dimmer function ON or OFF ON: Active dimmer function on
OFF: Active dimmer function off- Tail Light SW Taillight switch ON or OFF ON: Light control switch in tail or head position
OFF: Light control switch off or AUTO- Reverse Signal Reverse signal ON or OFF ON: Shift lever in R
OFF: Shift lever not in R- Parking Brake Parking brake switch ON or OFF ON: Parking brake applied
OFF: Parking brake released- Ignition Power switch ON or OFF ON: Power switch on (IG)
OFF: Power switch off or on (ACC)"OFF" is displayed even though the power switch is on (ACC) Vehicle Speed Maximum wheel speed sensor reading Min.: 0 km/h (0 mph), Max.: 255 km/h (158 mph) Vehicle stopped: 0 km/h (0 mph) When driving at constant speed: No large fluctuations HDMI Line (Blu-ray Disc Player) - Disconnected or Connected Disconnected Not available