LEMON Manuals: Even more car manuals for everyone
Home >> Toyota >> 2022 >> Avalon XLE >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 117 (Electronically Controlled Brake System - Diagnostic Codes (C1311-C1413) (Hybrid)) >> ELECTRONICALLY CONTROLLED BRAKE SYSTEM (for HV Model) >> DTC C1352: Increasing Pressure Solenoid (FR); DTC C1353: Increasing Pressure Solenoid (FL); DTC C1354: Increasing Pressure Solenoid (RR); DTC C1355: Increasing Pressure Solenoid (RL); DTC C1356: Decreasing Pressure Solenoid (FR); DTC C1357: Decreasing Pressure Solenoid (FL); DTC C1358: Decreasing Pressure Solenoid (RR); DTC C1359: Decreasing Pressure Solenoid (RL) [04/2018 -] >> Typical Enabling Conditions

Typical Enabling Conditions

WARNING: This page is about a different variant/trim than selected.
ALL

Monitor runs whenever the following DTCs are not stored None
C12A6, C12BC, C12D2 AND C12E8 (CASE 1 AND 2)

Serial communication with low side IC Valid
C12A7, C12BD, C12D3 AND C12E9

All of the following conditions are met -
Power supply for ABS solenoid Higher than 9.13 V
Serial communication with low side IC Valid
Output duty cycle Higher than 40%
ABS holding solenoid current monitor Normal
ABS solenoid power supply relay On
C12A8, C12B3, C12BE, C12C9, C12D4, C12DF, C12EA AND C12F5 (CASE 1)

Both of the following conditions are met -
Serial communication with low side IC Valid
Current monitor power supply Higher than 1.2 V, and less than 1.38 V
C12A8, C12BE, C12D4 AND C12EA (CASE 2)

All of the following conditions are met -
Serial communication with low side IC Valid
ABS solenoid power supply relay On
Output duty cycle 0%
C12A8, C12BE, C12D4 AND C12EA (CASE 3)

All of the following conditions are met -
Serial communication with low side IC Valid
Power supply for ABS solenoid Higher than 9.13 V
Output duty cycle 0%
ABS solenoid power supply relay On
C12B2, C12C8, C12DE AND C12F4

All of the following conditions are met -
ABS solenoid power supply relay On
Serial communication with low side IC Valid
Command to reduction solenoid on/off On
ABS reduction solenoid current Less than 4.4 A
C12B3, C12C9, C12DF AND C12F5 (CASE 2)

All of the following conditions are met -
Serial communication with low side IC Valid
ABS solenoid power supply relay On
Command to reduction solenoid on/off Off
C12B3, C12C9, C12DF AND C12F5 (CASE 3)

All of the following conditions are met -
Serial communication with low side IC Valid
Power supply for ABS solenoid Higher than 9.13 V
Command to reduction solenoid on/off Off
ABS solenoid power supply relay On
scientia non olet · About LEMON Manuals