Removal [08/2021 -]: Procedure

WARNING: This page is about a different variant/trim than selected.

PRECAUTION
NOTE:
After turning the power switch off, waiting time may be required before disconnecting the cable from the negative (-) auxiliary battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) auxiliary battery terminal notices before proceeding with work.

Refer to PRECAUTION [04/2018 -]
CHANGE POWER TILT AND POWER TELESCOPIC STEERING COLUMN SYSTEM SETTINGS (for Power Tilt and Power Telescopic Steering Column)
Refer to PROCEDURE - Step 2
REMOVE LOWER NO. 2 INSTRUMENT PANEL AIRBAG ASSEMBLY
Refer to REMOVAL [08/2021 -]
REMOVE LOWER INSTRUMENT PANEL FINISH PANEL LH
Refer to PROCEDURE - Step 3
REMOVE LOWER INSTRUMENT PANEL FINISH PANEL RH
Refer to PROCEDURE - Step 4
REMOVE FRONT CONSOLE UPPER PANEL GARNISH
Refer to PROCEDURE - Step 5
REMOVE CONSOLE BOX POCKET SUB-ASSEMBLY
Refer to PROCEDURE - Step 6
REMOVE CENTER INSTRUMENT CLUSTER FINISH PANEL SUB-ASSEMBLY
Refer to PROCEDURE - Step 7
REMOVE SHIFT LEVER KNOB SUB-ASSEMBLY
Refer to PROCEDURE - Step 1
REMOVE REAR UPPER CONSOLE PANEL SUB-ASSEMBLY
Refer to PROCEDURE - Step 9
REMOVE CONSOLE BOX BEZEL
Refer to PROCEDURE - Step 11
REMOVE CENTER NO. 1 INSTRUMENT CLUSTER FINISH PANEL
Refer to PROCEDURE - Step 13
REMOVE CENTER NO. 2 INSTRUMENT CLUSTER FINISH PANEL
Refer to PROCEDURE - Step 14
REMOVE RADIO AND DISPLAY RECEIVER ASSEMBLY WITH BRACKET
Refer to PROCEDURE - Step 9
REMOVE LOWER INSTRUMENT PANEL SUB-ASSEMBLY
Refer to PROCEDURE - Step 24
REMOVE LOWER NO. 2 INSTRUMENT PANEL FINISH PANEL
Refer to PROCEDURE - Step 11
REMOVE LOWER CENTER INSTRUMENT PANEL FINISH PANEL
Refer to PROCEDURE - Step 25
REMOVE INSTRUMENT CLUSTER FINISH PANEL GARNISH ASSEMBLY
Refer to PROCEDURE - Step 29
REMOVE LOWER INSTRUMENT PANEL FINISH PANEL ASSEMBLY
Refer to PROCEDURE - Step 30

REMOVE POWER SWITCH

Disengage the 2 claws and remove the power switch from lower instrument panel finish panel assembly.