Installation [08/2019 -]: Procedure

WARNING: This page is about a different variant/trim than selected.

INSTALL BATTERY STATE SENSOR ASSEMBLY
1. Connect the battery state sensor assembly connector.
2. Install the battery state sensor assembly to the auxiliary battery and tighten the nut.
  Torque: 5.4 N*m (55 kgf*cm, 48 in.*lbf)
3. Connect the No. 2 frame wire to the battery state sensor assembly with the nut.
  Torque: 7.6 N*m (77 kgf*cm, 67 in.*lbf)
  
  NOTE:
  When disconnecting the engine wire, some systems need to be initialized after the engine wire is reconnected.
  
  Refer to INITIALIZATION [04/2018 - 08/2020] , or refer to INITIALIZATION [08/2020 - 08/2021] , or refer to INITIALIZATION [08/2021 -]
INSTALL LUGGAGE TRIM SERVICE HOLE COVER
Refer to PROCEDURE - Step 3