DTC Check / Clear [04/2018 - ]

WARNING: This page is about a different variant/trim than selected.

CHECK DTC

Connect the Techstream to the DLC3.
Turn the power switch on (IG).
Turn the Techstream on.
Enter the following menus: Chassis / Parking Assist Camera / Trouble Codes.
Chassis > Parking Assist Camera > Trouble Codes
Enter the following menus: Body Electrical / Navigation System / Trouble Codes.
Body Electrical > Navigation System > Trouble Codes

Check for DTCs.

Refer to DIAGNOSTIC TROUBLE CODE CHART [04/2018 - ]

NOTE:

The radio and display receiver assembly outputs DTCs for the following system. When DTCs other than those in Diagnostic Trouble Code Chart for the parking assist monitor system are output, refer to Diagnostic Trouble Code Chart for the relevant systems.

System	Proceed to
Audio and Visual System*1	Refer to DIAGNOSTIC TROUBLE CODE CHART [04/2018 - 08/2019] , or refer to DIAGNOSTIC TROUBLE CODE CHART [08/2019 - 08/2020] , or refer to DIAGNOSTIC TROUBLE CODE CHART [08/2020 - ]
Navigation System*2	Refer to DIAGNOSTIC TROUBLE CODE CHART [04/2018 - 08/2019] , or refer to DIAGNOSTIC TROUBLE CODE CHART [08/2019 - 08/2020] , or refer to DIAGNOSTIC TROUBLE CODE CHART [08/2020 - ]

*1: w/o Navigation System
*2: w/ Navigation System

CLEAR DTC
1. Connect the Techstream to the DLC3.
2. Turn the power switch on (IG).
3. Turn the Techstream on.
4. Enter the following menus: Chassis / Parking Assist Camera / Trouble Codes.
  Chassis > Parking Assist Camera > Clear DTCs
5. Enter the following menus: Body Electrical / Navigation System / Trouble Codes.
  Body Electrical > Navigation System > Clear DTCs
6. Clear the DTCs.