LEMON Manuals: Even more car manuals for everyone
Home >> Toyota >> 2022 >> Avalon XLE >> Repair and Diagnosis >> External Pages >> Different car >> Section 63 (Safety Connect System - Diagnostics - Introduction (Except Hybrid)) >> SAFETY CONNECT SYSTEM (for Gasoline Model) >> Diagnosis System [04/2018 - 08/2020] >> Diagnosis System [04/2018 - 08/2020]

Diagnosis System [04/2018 - 08/2020]

WARNING: This page is about a different car, the 2020 Toyota Avalon and 2019 Toyota Avalon. However, it is still accessible from the selected car via links, so may be relevant.
  1. DESCRIPTION 
    1. The DCM (Telematics Transceiver) control the vehicle safety connect system functions. Safety connect system data and Diagnostic Trouble Codes (DTCs) can be read through the vehicle Data Link Connector 3 (DLC3). In some cases, a malfunction may be occurring in the safety connect system. When the system seems to be malfunctioning, use the Techstream to check for malfunctions and perform repairs.
  2. CHECK DLC3 
    1. Check the DLC3.

      Refer to GENERAL INFORMATION [04/2018 - ]

  3. INSPECT BATTERY VOLTAGE 
    1. Measure the battery voltage.

      Standard Voltage

      11 to 14 V

      If the voltage is below 11 V, recharge or replace the battery.

  4. CHECK INDICATOR 
    1. When a malfunction is detected in the safety connect system, the manual (SOS) switch red indicator on the manual (SOS) switch illuminates to inform the driver of the malfunction.

      Refer to SYSTEM DESCRIPTION [04/2018 - 08/2020] 

scientia non olet · About LEMON Manuals