Caution / Notice / Hint
WARNING: This page is about a different car, the 2020 Toyota Avalon and 2019 Toyota Avalon. However, it is still accessible from the selected car via links, so may be relevant.
The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed and installed, or replaced during vehicle approaching speaker controller removal/installation are shown below.
NECESSARY PROCEDURE AFTER PARTS REMOVED/INSTALLED/REPLACED (FOR HV MODEL)
| Replaced Part or Performed Procedure | Necessary Procedure | Effect/Inoperative Function When Necessary Procedures are not Performed | Link |
|---|---|---|---|
| Disconnect cable from negative auxiliary battery terminal | Perform steering sensor zero point calibration | Lane departure alert system (w/ Steering Control) | Refer to INITIALIZATION [04/2018 - 08/2021] |
| Pre-collision system | |||
| Intelligent clearance sonar system* | |||
| Lighting system (for HV Model with Cornering Light) | |||
| Memorize steering angle neutral point | Parking assist monitor system | Refer to INITIALIZATION [04/2018 -] | |
| Panoramic view monitor system | Refer to INITIALIZATION [04/2018 -] |
*: When performing learning using the Techstream.