Installation [08/2020 - ]: Procedure

1. Using height adjustment attachments and plate lift attachments, place the engine assembly on a flat level surface.
   NOTE:

   • Using height adjustment attachments and plate lift attachments, keep the engine assembly level.
   • To prevent the No. 2 oil pan sub-assembly from deforming, do not place any attachments under the No. 2 oil pan sub-assembly of the engine assembly.
   • Using an engine sling device and engine lift, secure the engine assembly before servicing.
2. Apply MP grease to the lip of a new rear engine oil seal.
   NOTE:

   • Keep the lip free from foreign matter.
   • Do not allow MP grease to contact the dust seal.
3. Using SST and a hammer, tap in the rear engine oil seal.

   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

   *a	-0.9 to 1.1 mm

   • SST: 09223-15030 
   • SST: 09950-70010 
     1. 09951-07150

   Standard Depth

   -0.9 to 1.1 mm (-0.0354 to 0.0433 in.) (From the edge of the cylinder block sub-assembly and stiffening crankcase assembly)

   NOTE:

   Do not tap in the rear engine oil seal at an angle.

1. Install the No. 1 crankshaft position sensor plate.

   HINT: 

   Align the pin hole of the No. 1 crankshaft position sensor plate with the pin of the crankshaft.

   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

1. Using SST, hold the crankshaft pulley assembly.

   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

   • SST: 09213-54015 
   • SST: 09330-00021 
2. Clean the 8 bolts and bolt holes.
3. Install the drive plate and ring gear sub-assembly and rear drive plate spacer to the crankshaft.

   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

   *1	Drive Plate and Ring Gear Sub-assembly
   *2	Rear Drive Plate Spacer
   *3	No. 1 Crankshaft Position Sensor Plate
   	Transaxle Side

   NOTE:

   As the rear drive plate spacer, drive plate and ring gear sub-assembly and No. 1 crankshaft position sensor plate are not reversible, be sure to install them so that they are facing in the direction shown in the illustration.

4. Apply adhesive to 2 or 3 threads at the end of each of the 8 bolts.

   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

   *a

   Adhesive

   Adhesive

   Toyota Genuine Adhesive 1324, Three Bond 1324 or equivalent

5. Install and uniformly tighten the 8 bolts in several steps in the sequence shown in the illustration.

   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

   Torque: 150 N*m (1530 kgf*cm, 111 ft.*lbf) 

   NOTE:

   Do not start the engine for at least 1 hour after installing the drive plate and ring gear sub-assembly.

Refer to INSTALLATION [08/2020 - ]