Installation [08/2020 - ]: Procedure
WARNING: This page is about a different car, the 2021 Toyota Avalon. However, it is still accessible from the selected car via links, so may be relevant.
- INSTALL TRANSMISSION CONTROL CABLE ASSEMBLY
- Pass the transmission control cable assembly into the vehicle and install the transmission control cable assembly to the vehicle body with the 2 nuts.
Torque: 6.0 N*m (61 kgf*cm, 53 in.*lbf)
- Connect the transmission control cable assembly to the vehicle body with the 2 nuts.
Torque: 6.0 N*m (61 kgf*cm, 53 in.*lbf)
- Connect the transmission control cable assembly to the No. 1 transmission control cable bracket with a new clip.
- Connect the transmission control cable assembly to the transmission control shaft lever as shown in the illustration.
*a Correct *b Incorrect NOTE:Before installing the transmission control cable assembly, check that the park/neutral position switch assembly and shift lever are in N.
- Pass the transmission control cable assembly into the vehicle and install the transmission control cable assembly to the vehicle body with the 2 nuts.
- INSTALL NO. 1 CONSOLE BOX DUCT
- Install the No. 1 console box duct.
- INSTALL TRANSMISSION FLOOR SHIFT ASSEMBLY
Refer to INSTALLATION [08/2020 - ]
- INSTALL FRONT LOWER NO. 1 FLOOR HEAT INSULATOR
- Install the front lower No. 1 floor heat insulator to the vehicle body with the 2 nuts.
Torque: 4.9 N*m (50 kgf*cm, 43 in.*lbf)
- Install the front lower No. 1 floor heat insulator to the vehicle body with the 2 nuts.
- INSTALL FRONT EXHAUST PIPE ASSEMBLY (TWC: Rear Catalyst)
Refer to INSTALLATION [08/2020 - ]
- INSTALL BATTERY CLAMP SUB-ASSEMBLY
Refer to PROCEDURE - Step 42
- INSTALL ECM
Refer to INSTALLATION [08/2020 - ]
- INSTALL BATTERY
Refer to INSTALLATION [08/2020 - ]
- INSPECT SHIFT LEVER POSITION
See step 2
- ADJUST SHIFT LEVER POSITION
Refer to ADJUSTMENT [08/2020 - ]