Adjustment [08/2020 - ]: Procedure

WARNING: This page is about a different car, the 2021 Toyota Avalon. However, it is still accessible from the selected car via links, so may be relevant.

SECURE VEHICLE

Fully apply the parking brake and chock a wheel.

WARNING:

Make sure to apply the parking brake and chock a wheel before performing this procedure.
If the vehicle is not secure and the shift lever is moved to N, the vehicle may suddenly move, possibly resulting in an accident or serious injury.

Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

DISCONNECT TRANSMISSION CONTROL CABLE ASSEMBLY
Refer to REMOVAL [08/2020 - ]

ADJUST PARK/NEUTRAL POSITION SWITCH ASSEMBLY

Disconnect the park/neutral position switch assembly connector.

Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

Remove the nut, washer and transmission control shaft lever from the manual valve lever shaft sub-assembly.

Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

Loosen the 2 bolts of the park/neutral position switch assembly.

Align the protrusion with the neutral basic line.

*a	Neutral Basic Line
*b	Protrusion

Hold the park/neutral position switch assembly in position and tighten the 2 bolts.
Torque: 5.4 N*m (55 kgf*cm, 48 in.*lbf)
Install the transmission control shaft lever to the manual valve lever shaft sub-assembly with the washer and nut.
Torque: 12.7 N*m (130 kgf*cm, 9 ft.*lbf)
Connect the park/neutral position switch assembly connector.

CONNECT TRANSMISSION CONTROL CABLE ASSEMBLY
Refer to INSTALLATION [08/2020 - ]
INSPECT PARK/NEUTRAL POSITION SWITCH ASSEMBLY OPERATION
See step 2