Installation [08/2020 - ]: Procedure
WARNING: This page is about a different car, the 2021 Toyota Avalon. However, it is still accessible from the selected car via links, so may be relevant.
- INSTALL STARTER ASSEMBLY
- Install the starter assembly to the cylinder block sub-assembly with the 2 bolts.
Torque: 46 N*m (469 kgf*cm, 34 ft.*lbf)
- Connect the No. 2 engine wire to terminal 30 with the nut.
Torque: 9.8 N*m (100 kgf*cm, 87 in.*lbf)
- Close the terminal cap.
- Connect the starter assembly connector.
- Install the starter assembly to the cylinder block sub-assembly with the 2 bolts.
- INSTALL FLYWHEEL HOUSING SIDE COVER
- Align the protrusion with the cylinder block sub-assembly and engage the claw as shown in the illustration to install the flywheel housing side cover.NOTE:
- Make sure the claw makes a click sound, indicating that it fits tightly.
- Replace the flywheel housing side cover with a new one if the claw does not fit tightly or is deformed.
- Align the protrusion with the cylinder block sub-assembly and engage the claw as shown in the illustration to install the flywheel housing side cover.
- INSTALL FRONT ENGINE MOUNTING INSULATOR
Refer to INSTALLATION [08/2020 - ]
- CONNECT CABLE TO NEGATIVE BATTERY TERMINAL
Refer to PROCEDURE - Step 2