LEMON Manuals: Even more car manuals for everyone
Home >> Toyota >> 2022 >> Avalon XLE >> Repair and Diagnosis >> External Pages >> Different car >> Section 28 (Engine Control System (Service Information) [A25A-FKS]) >> VACUUM SWITCHING VALVE (for Engine Mounting) >> Removal [08/2020 - ] >> Procedure

Removal [08/2020 - ]: Procedure

WARNING: This page is about a different car, the 2021 Toyota Avalon. However, it is still accessible from the selected car via links, so may be relevant.
  1. REMOVE COOL AIR INTAKE DUCT SEAL 

    Refer to PROCEDURE - Step 1 [04/2018 - 08/2021] , or refer to PROCEDURE - Step 1 [08/2021 - ]

  2. REMOVE NO. 1 ENGINE COVER SUB-ASSEMBLY 

    Refer to PROCEDURE - Step 20

  3. REMOVE INLET AIR CLEANER ASSEMBLY 

    Refer to PROCEDURE - Step 21

  4. REMOVE AIR CLEANER ASSEMBLY WITH AIR CLEANER HOSE 

    Refer to PROCEDURE - Step 22

  5. REMOVE VACUUM SWITCHING VALVE (for Active Control Engine Mount System) 
    1. Remove the bolt and disengage the 2 wire harness clamps to separate the engine wire.
      GTY948634Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    2. Remove the bolt and wire harness clamp bracket from the transmission case side cover.
      GTY948405Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    3. Disengage the wire harness clamp and disconnect the vacuum switching valve (for active control engine mount system) connector.
      GTY948633Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    4. Disconnect the 3 vacuum hoses from the vacuum switching valve (for active control engine mount system).
      GTY948632Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    5. Remove the nut and vacuum switching valve (for active control engine mount system) from the front engine mounting insulator.
scientia non olet · About LEMON Manuals