Installation [08/2020 - ]: Procedure
WARNING: This page is about a different car, the 2021 Toyota Avalon. However, it is still accessible from the selected car via links, so may be relevant.
- INSTALL SPARK PLUG
Refer to PROCEDURE - Step 1
- INSTALL IGNITION COIL ASSEMBLY
HINT:
Perform "Inspection After Repair" after replacing an ignition coil assembly.
Refer to INITIALIZATION [08/2020 - ]
- Using an 8 mm socket wrench, install the 4 ignition coil assemblies to the cylinder head cover sub-assembly with the 4 bolts.
Torque: 7.5 N*m (76 kgf*cm, 66 in.*lbf)
NOTE:If an ignition coil assembly has been struck or dropped, replace it.
HINT:
Install the same parts to their original positions.
- Connect the 4 ignition coil assembly connectors.
- Using an 8 mm socket wrench, install the 4 ignition coil assemblies to the cylinder head cover sub-assembly with the 4 bolts.
- INSTALL NO. 1 ENGINE COVER SUB-ASSEMBLY
Refer to PROCEDURE - Step 47
- PERFORM INITIALIZATION
- Perform "Inspection After Repair" after replacing an ignition coil assembly or spark plug.
Refer to INITIALIZATION [08/2020 - ]
- Perform "Inspection After Repair" after replacing an ignition coil assembly or spark plug.