Installation [08/2020 - ]: Procedure
WARNING: This page is about a different car, the 2021 Toyota Avalon. However, it is still accessible from the selected car via links, so may be relevant.
- INSTALL NO. 2 FUEL PRESSURE SENSOR
HINT:
Perform "Inspection After Repair" after replacing the No. 2 fuel pressure sensor.
Refer to INITIALIZATION [08/2020 - ]
- Install a new O-ring to the No. 2 fuel pressure sensor.
- Install the No. 2 fuel pressure sensor holder to the No. 2 fuel pressure sensor as shown in the illustration.
*1 No. 2 Fuel Pressure Sensor *2 No. 2 Fuel Pressure Sensor Holder *a Flat - Using an 8 mm socket wrench, install the No. 2 fuel pressure sensor with the No. 2 fuel pressure sensor holder to the fuel delivery pipe sub-assembly with the bolt.
Torque: 10 N*m (02 kgf*cm, 7 ft.*lbf)
- Connect the No. 2 fuel pressure sensor connector.
- INSTALL FUEL(ENGINE ROOM SIDE) PUMP ASSEMBLY
Refer to INSTALLATION [08/2020 - ]
- PERFORM INITIALIZATION
- Perform "Inspection After Repair" after replacing the No. 2 fuel pressure sensor.
Refer to INITIALIZATION [08/2020 - ]
- Perform "Inspection After Repair" after replacing the No. 2 fuel pressure sensor.