LEMON Manuals: Even more car manuals for everyone
Home >> Toyota >> 2022 >> Avalon XLE >> Repair and Diagnosis >> External Pages >> Different car >> Section 27 (Fuel System (Service Information) [A25A-FKS]) >> Fuel Main Valve >> Installation [08/2020 - ] >> Procedure

Installation [08/2020 - ]: Procedure

WARNING: This page is about a different car, the 2021 Toyota Avalon. However, it is still accessible from the selected car via links, so may be relevant.
  1. INSTALL FUEL MAIN VALVE ASSEMBLY 
    1. Apply gasoline to a new O-ring. Then install the O-ring to the fuel main valve assembly.
      NOTE:

      Make sure that there is no clearance between the fuel main valve assembly and mesh.

      GTY759962Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
      *1 Fuel Main Valve Assembly
      *a Mesh
      *b Mini-clip
      *c No Clearance
    2. Install the fuel main valve assembly to the fuel suction tube with pump and gauge assembly.
      NOTE:

      Make sure that the O-ring is not cut or pinched during installation.

  2. INSTALL FUEL PRESSURE REGULATOR HOLDER 
    1. Engage the 2 claws to install the fuel pressure regulator holder to the fuel suction tube with pump and gauge assembly.
  3. INSTALL FUEL SUCTION TUBE WITH PUMP AND GAUGE ASSEMBLY 

    Refer to INSTALLATION [08/2020 - ] 

scientia non olet · About LEMON Manuals