Components [08/2020 - ]

WARNING: This page is about a different car, the 2021 Toyota Avalon. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Exhaust Manifold Replacement Components With Torque Specifications (1 Of 5)

Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

Callout	Description	Callout	Description
*1	FRONT CENTER UPPER SUSPENSION BRACE SUB-ASSEMBLY	-	-
	Tightening torque for "Major areas involving basic vehicle performance such as moving/turning/stopping": Nm (kgfcm, ft.*lbf)		Nm (kgfcm, ft.*lbf): Specified torque
*T1	Bolt color black: 8.0 Nm (82 kgfcm, 71 in.lbf) Bolt color silver: 8.9 Nm (91 kgfcm, 79 in.lbf)	-	-

Fig 2: Exhaust Manifold Replacement Components With Torque Specifications (2 Of 5)

Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

Callout	Description	Callout	Description
*1	FRONT WHEEL OPENING EXTENSION PAD LH	*2	FRONT WHEEL OPENING EXTENSION PAD RH
*3	NO. 1 ENGINE UNDER COVER	*4	NO. 2 ENGINE UNDER COVER ASSEMBLY
	Nm (kgfcm, ft.*lbf): Specified torque	-	-

Fig 3: Exhaust Manifold Replacement Components With Torque Specifications (3 Of 5)

Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

Callout	Description	Callout	Description
*1	FRONT FLOOR COVER LH	*2	FRONT FLOOR COVER RH
	Nm (kgfcm, ft.*lbf): Specified torque	-	-

Fig 4: Exhaust Manifold Replacement Components With Torque Specifications (4 Of 5)

Callout	Description	Callout	Description
*1	FRONT EXHAUST PIPE ASSEMBLY (TWC: Rear Catalyst)	*2	NO. 1 UPPER FRONT FLOOR HEAT INSULATOR
*3	FRONT LOWER NO. 1 FLOOR HEAT INSULATOR	*4	CENTER FLOOR CROSSMEMBER BRACE
*5	FRONT CENTER FLOOR BRACE	*6	EXHAUST PIPE SUPPORT
*7	GASKET	-	-
	Nm (kgfcm, ft.*lbf): Specified torque	*	For use with a union nut wrench
•	Non-reusable part	-	-

Fig 5: Exhaust Manifold Replacement Components With Torque Specifications (5 Of 5)

Callout	Description	Callout	Description
*1	EXHAUST MANIFOLD (TWC: Front Catalyst)	*2	MANIFOLD STAY
*3	NO. 1 EXHAUST MANIFOLD HEAT INSULATOR	*4	NO. 2 EXHAUST MANIFOLD HEAT INSULATOR
*5	EXHAUST MANIFOLD TO HEAD GASKET	*6	WIRE HARNESS CLAMP BRACKET
	Nm (kgfcm, ft.*lbf): Specified torque	*	For use with a union nut wrench
•	Non-reusable part	-	-