Installation [08/2020 - ]: Procedure

WARNING: This page is about a different car, the 2021 Toyota Avalon. However, it is still accessible from the selected car via links, so may be relevant.

INSTALL LEAK DETECTION PUMP SUB-ASSEMBLY

HINT:

Only perform this procedure when replacement of the leak detection pump sub-assembly is necessary.

Engage the 2 claws to install a new leak detection pump sub-assembly to the No. 2 charcoal canister sub-assembly.

Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

NOTE:

Do not allow foreign matter such as grease, oil or water to adhere to the O-ring.
Ensure that the claws are engaged properly.

INSTALL NO. 2 CHARCOAL CANISTER SUB-ASSEMBLY

Install the No. 2 charcoal canister sub-assembly to the vehicle body with the 3 nuts.
Torque: 8.0 N*m (82 kgf*cm, 71 in.*lbf)
Connect the leak detection pump sub-assembly connector.

Push the air line tube onto the (leak detection pump sub-assembly) and push in the retainer to engage the lock claws.

NOTE:

Check that there are no scratches or foreign matter around the connecting parts of the tube connector and pipe (leak detection pump sub-assembly) before performing this work.
After connecting the air line tube, check that the air line tube is securely connected by pulling on the tube connector.

Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

*a	Retainer
	Push in

Engage the 2 clamps.

INSTALL CANISTER (CHARCOAL CANISTER ASSEMBLY)

Install the clip to the vehicle body.

Engage the claw to install the canister (charcoal canister assembly) to the vehicle body as shown in the illustration.

Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

Engage the clip to the canister (charcoal canister assembly).
Install the 2 bolts.
Torque: 8.0 N*m (82 kgf*cm, 71 in.*lbf)
Connect the purge line hose to the canister (charcoal canister assembly) and slide the clip to secure it.

Push the vent line hose onto the canister (charcoal canister assembly) and push in the retainer to engage the lock claws.

NOTE:

Check that there are no scratches or foreign matter around the connecting parts of the tube connector and pipe (canister (charcoal canister assembly)) before performing this work.
After connecting the vent line hose, check that the vent line hose is securely connected by pulling on the tube connector.

*a	Retainer
	Push in

Push the fuel tank vent hose onto the canister (charcoal canister assembly) and push in the retainer to engage the lock claws.

NOTE:

Check that there are no scratches or foreign matter around the connecting parts of the tube connector and pipe (canister (charcoal canister assembly)) before performing this work.
After connecting the fuel tank vent hose, check that the fuel tank vent hose is securely connected by pulling on the tube connector.

*a	Retainer
	Push in

INSTALL NO. 1 REAR FLOOR BOARD

Engage the 3 clamps (A) and 2 clamps (B) to install the No. 1 rear floor board to the vehicle body.

Install the 4 clips.