DTC P2614-01: Camshaft Position Signal Output "A" General Electrical Failure [08/2020 - ]: Procedure

WARNING: This page is about a different car, the 2021 Toyota Avalon. However, it is still accessible from the selected car via links, so may be relevant.

REPLACE CAM TIMING CONTROL MOTOR WITH EDU ASSEMBLY

Replace the cam timing control motor with EDU assembly.

Refer to REMOVAL [08/2020 - ]

HINT:

Perform "Inspection After Repair" after replacing the cam timing control motor with EDU assembly.

Refer to INITIALIZATION [08/2020 - ]

Result

Proceed to
NEXT

Result:

See step 2

CLEAR DTC

Connect the Techstream to the DLC3.
Turn the engine switch on (IG).
Turn the Techstream on.
Clear the DTCs.
Powertrain > Engine > Clear DTCs

Turn the engine switch off and wait for at least 30 seconds.

Result

Proceed to
NEXT

Result:

See step 3

CONFIRM WHETHER MALFUNCTION HAS BEEN SUCCESSFULLY REPAIRED

Drive the vehicle in accordance with the driving pattern described in the Confirmation Driving Pattern.
Enter the following menus: Powertrain / Engine / Trouble Codes.

Read the DTCs.

Powertrain > Engine > Trouble Codes

Result

Result	Proceed to
DTCs are not output	A
DTC P2614-01 is output	B

Result:

END

Result:

REPLACE ECM. Refer to REMOVAL [08/2020 - ]