DTC P0011-00: Camshaft Position "A" - Timing Over-Advanced or System Performance Bank 1 [08/2020 - ]: Procedure
WARNING: This page is about a different car, the 2021 Toyota Avalon. However, it is still accessible from the selected car via links, so may be relevant.
- CHECK ANY OTHER DTCS OUTPUT (IN ADDITION TO DTC P0011-00)
- Connect the Techstream to the DLC3.
- Turn the engine switch on (IG).
- Turn the Techstream on.
- Enter the following menus: Powertrain / Engine / Trouble Codes.
- Read the DTCs.
Powertrain > Engine > Trouble Codes
Result
Result Proceed to DTC P0011-00 is output A DTC P0011-00 and other DTCs are output B HINT:
If any DTCs other than P0011-00 are output, troubleshoot those DTCs first.
Result:
B
GO TO DTC CHART. Refer to DIAGNOSTIC TROUBLE CODE CHART [08/2020 - ]
Result:
A
See step 2
- REPLACE CAMSHAFT TIMING GEAR ASSEMBLY
- Replace the camshaft timing gear assembly.
Refer to PROCEDURE - Step 30
HINT:
Perform "Inspection After Repair" after replacing the camshaft timing gear assembly.
Refer to INITIALIZATION [08/2020 - ]
Result
Proceed to NEXT
Result:
NEXT
See step 3
- Replace the camshaft timing gear assembly.
- CLEAR DTC
- Connect the Techstream to the DLC3.
- Turn the engine switch on (IG).
- Turn the Techstream on.
- Clear the DTCs.
Powertrain > Engine > Clear DTCs
- Turn the engine switch off and wait for at least 30 seconds.
Result
Proceed to NEXT
Result:
NEXT
See step 4
- CONFIRM WHETHER MALFUNCTION HAS BEEN SUCCESSFULLY REPAIRED
- Drive the vehicle in accordance with the driving pattern described in the Confirmation Driving Pattern.
- Enter the following menus: Powertrain / Engine / Trouble Codes.
- Read the DTCs.
Powertrain > Engine > Trouble Codes
Result
Result Proceed to DTCs are not output A DTC P0011-00 is output B
Result:
A
END
Result:
B
REPLACE ECM. Refer to REMOVAL [08/2020 - ]