Installation [04/2018 - 08/2020]: Procedure

INSTALL BRAKE BOOSTER GASKET
1. Install a new brake booster gasket to the brake booster assembly.
INSTALL BRAKE BOOSTER ASSEMBLY
1. Temporarily install the brake booster assembly to the vehicle body.
  NOTE:
  Do not apply excessive force to the brake lines.
2. Temporarily install the lock nut and brake master cylinder push rod clevis to the brake booster assembly.
  NOTE:
  Fully tighten the lock nut when adjusting the brake pedal height.
3. Install the 4 nuts to secure the brake booster assembly.
  Torque: 12.8 N*m (131 kgf*cm, 9 ft.*lbf)
4. Connect the connector to the vacuum warning switch assembly.
INSTALL PUSH ROD PIN
See step 5
CONNECT UNION TO CHECK VALVE HOSE
1. Connect the union to check valve hose to the brake booster assembly, and slide the clip to secure it.

INSTALL BATTERY CLAMP SUB-ASSEMBLY

Install the battery clamp sub-assembly with the 3 bolts and nut.

Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

Bolt

Torque: 18.5 N*m (189 kgf*cm, 14 ft.*lbf)

Nut

Torque: 8.0 N*m (82 kgf*cm, 71 in.*lbf)

INSTALL AIR CLEANER ASSEMBLY WITH AIR CLEANER HOSE
Refer to PROCEDURE - Step 44
INSTALL FRONT CENTER UPPER SUSPENSION BRACE SUB-ASSEMBLY
Refer to PROCEDURE - Step 5
INSTALL COWL TOP VENTILATOR LOUVER SUB-ASSEMBLY
Refer to PROCEDURE - Step 3
INSTALL NO. 1 INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY
Refer to PROCEDURE - Step 47
INSTALL BRAKE MASTER CYLINDER SUB-ASSEMBLY
Refer to INSTALLATION [04/2018 - 08/2020]
INSPECT AND ADJUST BRAKE PEDAL
Refer to ADJUSTMENT [04/2018 - 08/2020]