DTC B15C0: GPS Antenna Connection Malfunction (short); DTC B15C1: GPS Antenna Connection Malfunction (break) [04/2018 -]: Procedure
- CHECK DTC
- Clear the DTCs.
Body Electrical > Navigation System > Clear DTCs
- Recheck for DTCs and check that no DTCs are output.
Body Electrical > Navigation System > Trouble Codes
OK
No DTCs are output.
Result
Proceed to OK NG
Result:
OK
USE SIMULATION METHOD TO CHECK. Refer to HOW TO PROCEED WITH TROUBLESHOOTING [04/2018 -]
Result:
NG
See step 2
- Clear the DTCs.
- INSPECT NO. 5 ANTENNA CORD SUB-ASSEMBLY
- Remove the No. 5 antenna cord sub-assembly.
Refer to REMOVAL [04/2018 - 08/2020] , or refer to REMOVAL [08/2020 -]
- Measure the resistance according to the value(s) in the table below.
*a Component without harness connected
(No. 5 Antenna Cord Sub-assembly)Standard Resistance
Tester Connection Condition Specified Condition C-1 - D-1 Always Below 1 Ω C-1a - D-1a Always Below 1 Ω C-1 or D-1 - Body ground Always 10 kΩ or higher Result
Proceed to OK NG
Result:
NG
REPLACE NO. 5 ANTENNA CORD SUB-ASSEMBLY. Refer to REMOVAL [04/2018 - 08/2020] , or refer to REMOVAL [08/2020 -]
Result:
OK
See step 3
- Remove the No. 5 antenna cord sub-assembly.
- INSPECT NO. 4 ANTENNA CORD SUB-ASSEMBLY
- Remove the No. 4 antenna cord sub-assembly.
Refer to REMOVAL [04/2018 - 08/2021] , or refer to REMOVAL [08/2021 -]
- Measure the resistance according to the value(s) in the table below.
*a Component without harness connected
(No. 4 Antenna Cord Sub-assembly)Standard Resistance
Tester Connection Condition Specified Condition A-3 - B-1 Always Below 1 Ω A-3a - B-1a Always Below 1 Ω A-3 or B-1 - Body ground Always 10 kΩ or higher Result
Proceed to OK NG
Result:
NG
REPLACE NO. 4 ANTENNA CORD SUB-ASSEMBLY. Refer to REMOVAL [04/2018 - 08/2021] , or refer to REMOVAL [08/2021 -]
Result:
OK
See step 4
- Remove the No. 4 antenna cord sub-assembly.
- INSPECT NAVIGATION ANTENNA ASSEMBLY
- Remove the navigation antenna assembly.
Refer to REMOVAL [04/2018 - 08/2020] , or refer to REMOVAL [08/2020 - 08/2021] , or refer to REMOVAL [08/2021 -]
- Inspect the navigation antenna assembly.
Refer to INSPECTION [04/2018 - 08/2020] , or refer to INSPECTION [08/2020 -]
Result
Proceed to OK NG
Result:
OK
REPLACE RADIO AND DISPLAY RECEIVER ASSEMBLY. Refer to REMOVAL [04/2018 -]
Result:
NG
REPLACE NAVIGATION ANTENNA ASSEMBLY. Refer to REMOVAL [04/2018 - 08/2020] , or refer to REMOVAL [08/2020 - 08/2021] , or refer to REMOVAL [08/2021 -]
- Remove the navigation antenna assembly.