Caution / Notice / Hint
NOTE:
When disconnecting the cable from the negative (-) battery terminal while performing repairs, some systems need to be initialized after the cable is reconnected (Refer to INITIALIZATION [08/2019 - 08/2022] , or refer to INITIALIZATION [08/2022 - ] ).
HINT:
To perform the simulation method, enter check mode (signal check) with the Techstream (Refer to CHECK MODE PROCEDURE [08/2015 - ] ), and then wiggle each connector of the airbag system or drive the vehicle on various types of road (Refer to DIAGNOSIS SYSTEM [08/2019 - ] ).