LEMON Manuals: Even more car manuals for everyone
Home >> Toyota >> 2022 >> 4Runner TRD Pro >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 4 (Transfer Case (VF2CM) - Service Information) >> Transfer Oil >> Replacement [08/2019 - ] >> Procedure

Replacement [08/2019 - ]: Procedure

WARNING: This page is about a different variant/trim than selected.
  1. DRAIN TRANSFER OIL 
    NOTE:
    GTY540659Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

    Before proceeding with work, wedge a cloth or similar item into the transfer case lower protector to prevent transfer oil from sticking to the transfer case protector cushion.

    1. Remove the filler plug and gasket.
      GTY934441Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    2. Remove the drain plug and gasket to drain the transfer oil.
    3. Install a new gasket to the drain plug, and then install the drain plug.

      Torque: 37 N.m (377 kgf/cm, 27 ft.lbf) 

      TEXT IN ILLUSTRATION

      *1 Filler Plug
      *2 Drain Plug
  2. ADD TRANSFER OIL 
    1. Add oil so that the oil level is between 0 to 5.0 mm (0 to 0.196 in.) from the bottom lip of the filler plug hole.
      TEXT IN ILLUSTRATION

      *a 0 to 5.0 mm

      Oil grade

      Toyota Genuine Transfer Gear Oil LF or Equivalent

      Viscosity

      SAE 75W

      Standard capacity

      1.0 liters (1.1 US qts, 0.9 Imp. qts)

      NOTE:

      Too much or too little oil will lead to transfer problems.

      GTY861651Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    2. Install a new gasket to the filler plug, and then install the filler plug.

      Torque: 37 N.m (377 kgf/cm, 27 ft.lbf) 

      NOTE:
      • When adding transfer oil, make sure the vehicle is level.
      • An excessively large or small amount of oil may cause problems.
      • After adding oil, drive the vehicle and recheck the oil level.
    3. Inspect for transfer oil leaks.
scientia non olet · About LEMON Manuals