On-Vehicle Inspection [08/2019 - ]: Procedure

WARNING: This page is about a different variant/trim than selected.

CHECK TRANSFER OIL

Remove the filler plug and gasket.

Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

TEXT IN ILLUSTRATION

*1	Filler Plug

Check that the oil level is between 0 to 5.0 mm (0 to 0.196 in.) from the bottom lip of the filler plug hole.

Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

If the result is not as specified, add transfer oil.

TEXT IN ILLUSTRATION

*a	0 to 5.0 mm

Oil grade

Toyota Genuine Transfer Gear Oil LF or Equivalent

Viscosity

SAE 75W

NOTE:

Too much or too little oil will lead to transfer problems.

When the oil level is too low, check for oil leakage.
Install a new gasket to the filler plug, and then install the filler plug.
Torque: 37 N.m (377 kgf/cm, 27 ft.lbf)