Replacement [08/2019 - ]: Procedure

WARNING: This page is about a different variant/trim than selected.

DRAIN TRANSFER OIL
See step 1
REMOVE PROPELLER WITH CENTER BEARING SHAFT ASSEMBLY
Refer to REMOVAL [08/2015 - ]
REMOVE REAR OUTPUT SHAFT COMPANION FLANGE SUB-ASSEMBLY
Refer to PROCEDURE - Step 9

REMOVE TRANSFER EXTENSION HOUSING TYPE T OIL SEAL

Using SST, remove the transfer extension housing type T oil seal.

Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

NOTE:

Be careful not to damage the transfer extension housing type T oil seal and extension housing contact surface.

INSTALL TRANSFER EXTENSION HOUSING TYPE T OIL SEAL

Coat the lip of a new transfer extension housing type T oil seal with MP grease.

Using SST and a hammer, install the transfer extension housing type T oil seal as shown in the illustration.

Drive in depth (A)

48.5 to 49.5 mm (1.910 to 1.948 in.)

NOTE:

Be careful not to damage the transfer extension housing type T oil seal.

INSTALL REAR OUTPUT SHAFT COMPANION FLANGE SUB-ASSEMBLY
Refer to PROCEDURE - Step 55
INSTALL PROPELLER WITH CENTER BEARING SHAFT ASSEMBLY
Refer to INSTALLATION [08/2015 - ]
ADD TRANSFER OIL
See step 2
CHECK FOR TRANSFER OIL LEAK