Installation [08/2019 - ]: Procedure

WARNING: This page is about a different variant/trim than selected.

INSTALL TRANSFER CASE LOWER PROTECTOR
1. Install the transfer case lower protector with the 4 bolts.
  Torque: 18 N.m (184 kgf/cm, 13 ft.lbf)

INSTALL TRANSFER ASSEMBLY

Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

Install the transfer assembly and 2 clamps with the 8 bolts.

TEXT IN ILLUSTRATION

Clamp

NOTE:

Do not damage the lip of the transfer adaptor oil seal.

Torque: 24 N.m (245 kgf/cm, 18 ft.lbf)

CONNECT TRANSFER BREATHER HOSE SUB-ASSEMBLY
1. Connect the 2 transfer breather hose sub-assemblies and attach the 2 clamps.

CONNECT WIRE HARNESS

Connect the connector and attach the 3 clamps.

CONNECT WIRE HARNESS AND CONNECTOR
Refer to PROCEDURE - Step 6
INSTALL REAR NO. 1 ENGINE MOUNTING INSULATOR
Refer to PROCEDURE - Step 7
INSTALL NO. 3 FRAME CROSSMEMBER SUB-ASSEMBLY
Refer to PROCEDURE - Step 8
INSTALL PROPELLER WITH CENTER BEARING SHAFT ASSEMBLY
Refer to INSTALLATION [08/2015 - ]
INSTALL FRONT PROPELLER SHAFT ASSEMBLY
Refer to INSTALLATION [08/2015 - ]
ADD TRANSFER OIL
See step 2
CHECK FOR TRANSFER OIL LEAK