DTC P0500: Vehicle Speed Sensor Malfunction [08/2015 - 08/2019]: Procedure
WARNING: This page is about a different car, the 2019 Toyota 4Runner, 2018 Toyota 4Runner, 2017 Toyota 4Runner, and 2016 Toyota 4Runner. However, it is still accessible from the selected car via links, so may be relevant.
- CHECK FOR DTC
- Clear the DTCs (Refer to DTC CHECK / CLEAR [08/2015 - 08/2019] ).
- Perform the following to make sure the DTC detection conditions are met.
HINT:
If the detection conditions are not met, the system cannot detect the malfunction.
- Drive the vehicle for more than 10 seconds when the engine coolant temperature is more than 20°C (68°F).
- Check for DTCs (Refer to DTC CHECK / CLEAR [08/2015 - 08/2019]
).
OK
DTC P0500 is not output.
RESULTResult Proceed to OK A NG B
Result:
A
USE SIMULATION METHOD TO CHECK
(Refer to HOW TO PROCEED WITH TROUBLESHOOTING [08/2015 - 08/2019] )
Result:
B
GO TO SFI SYSTEM
(Refer to HOW TO PROCEED WITH TROUBLESHOOTING [08/2015 - ] )