Removal [07/2020 - 10/2022]: Procedure
- PRECAUTION WARNING:
Be sure to read Precaution thoroughly before servicing.
Refer to PRECAUTION [07/2020 - 12/2021] , or refer to PRECAUTION [12/2021 - 10/2022]
NOTE:After the ignition switch is turned off, there may be a waiting time before disconnecting the negative (-) auxiliary battery terminal.
- REMOVE REAR NO. 2 FLOOR BOARD
Refer to PROCEDURE - Step 2
- REMOVE BATTERY HOLE COVER
Refer to PROCEDURE - Step 6
- DISCONNECT CABLE FROM NEGATIVE AUXILIARY BATTERY TERMINAL
Refer to PROCEDURE - Step 4
- REMOVE FRONT DOOR INSIDE HANDLE BEZEL
Refer to PROCEDURE - Step 5
- REMOVE FRONT DOOR ARMREST COVER
Refer to PROCEDURE - Step 6
- REMOVE FRONT DOOR TRIM BOARD SUB-ASSEMBLY
Refer to PROCEDURE - Step 7
- REMOVE FRONT DOOR WEATHERSTRIP CLIP
Refer to PROCEDURE - Step 17
- REMOVE FRONT DOOR SERVICE HOLE COVER
Refer to PROCEDURE - Step 18
- REMOVE SIDE AIRBAG PRESSURE SENSOR
- Check that the ignition switch is off.
- Check that the cable is disconnected from the negative (-) auxiliary battery terminal.WARNING:
Wait at least 60 seconds after disconnecting the cable from the negative (-) auxiliary battery terminal to disable the SRS system.
- Disconnect the connector from the side airbag pressure sensor.NOTE:
When disconnecting any airbag connector, take care not to damage the airbag wire harness.
HINT:
Refer to How to Connect or Disconnect Airbag Connector.
Refer to HOW TO CONNECT OR DISCONNECT AIRBAG CONNECTOR [07/2020 - 10/2022]
- Remove the nut and disengage the claw to remove the side airbag pressure sensor from the front door panel.