LEMON Manuals: Even more car manuals for everyone
Home >> Toyota >> 2021 >> Venza XLE >> Repair and Diagnosis >> Body & Frame >> Exterior Body Panels >> Exterior Panels / Trim - Service Information (2 Of 2) >> Rear Door Outside Moulding >> Removal [07/2020 - ] >> Procedure

Removal [07/2020 - ]: Procedure

  1. REMOVE HOLE PLUG 
    1. Remove the hole plug.
      GTY1013753Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  2. REMOVE REAR DOOR LOWER OUTSIDE MOULDING SUB-ASSEMBLY 
    1. Remove the nut.
      GTY1013741Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    2. Apply protective tape around the rear door lower outside moulding sub-assembly as shown in the illustration.
      GTY1013824Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
      Protective Tape
    3. Disengage the 9 clips and guide to remove the rear door lower outside moulding sub-assembly.
      GTY1014764Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
      Remove in this Direction
scientia non olet · About LEMON Manuals