Caution / Notice / Hint

NOTE:

When replacing the combination meter assembly, always replace it with a new one. If a combination meter assembly which was installed to another vehicle is used, the information stored in it will not match the information from the vehicle and a DTC may be stored.
When replacing the combination meter assembly, update the ECU security key.
Refer to UPDATE ECU SECURITY KEY [07/2020 - ]
After the ignition switch is turned off, there may be a waiting time before disconnecting the negative (-) auxiliary battery terminal.
Refer to BEFORE DISCONNECTING BATTERY [07/2020 - 10/2022]
If CAN communication DTCs are output by the ECUs, there may be a communication malfunction between the ECUs due to a power supply malfunction, etc. Before performing this procedure, inspect the CAN communication system.
Refer to HOW TO PROCEED WITH TROUBLESHOOTING [07/2020 - 10/2022]