Caution / Notice / Hint

The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are removed and installed, or replaced during combination meter assembly removal/installation are shown below.

NECESSARY PROCEDURES AFTER PARTS REMOVED/INSTALLED/REPLACED

Replaced Part or Performed Procedure	Necessary Procedures	Effect/Inoperative Function When Necessary Procedures are not Performed	Link
Auxiliary battery terminal is disconnected/reconnected	Memorize steering angle neutral point	Parking Assist Monitor System	Refer to INITIALIZATION [07/2020 - 10/2022]
	Memorize steering angle neutral point	Panoramic View Monitor System	Refer to INITIALIZATION [07/2020 - 10/2022]
	Reset back door close position	Power Back Door System	Refer to INITIALIZATION [07/2020 - ]
Combination meter assembly	Update ECU security key	Vehicle Control History (RoB) are stored	Refer to UPDATE ECU SECURITY KEY [07/2020 - ]

HINT:

When the cable is disconnected / reconnected to the auxiliary battery terminal, systems temporarily stop operating. However, each system has a function that completes learning the first time the system is used.

LEARNING COMPLETES WHEN VEHICLE IS DRIVEN

Effect/Inoperative Function When Necessary Procedures are not Performed	Necessary Procedures	Link
Lane Tracing Assist System	Drive the vehicle straight ahead at 35 km/h (22 mph) or more for 5 second or more.	Refer to INITIALIZATION [07/2020 - ]
Pre-collision System		Refer to INITIALIZATION [07/2020 - ]

LEARNING COMPLETES WHEN VEHICLE IS OPERATED NORMALLY

Effect/Inoperative Function When Necessary Procedures are not Performed	Necessary Procedures	Link
Power Door Lock Control System Back door opener	Perform door unlock operation with door control switch or electrical key transmitter sub-assembly switch.	Refer to INITIALIZATION [07/2020 - ]
Air Conditioning System	After the ignition switch is turned to ON, the servo motor standard position is recognized.	-