DTC B009E-83: Right Side Restraints Sensor 5 Value of Signal Protection Calculation Incorrect [07/2020 - 10/2022]: Procedure

1. Turn the ignition switch to ON, and wait for at least 60 seconds.
2. Check for DTCs.

   Body Electrical > SRS Airbag > Trouble Codes 

   Result

   Proceed to
   DTC B009E-83 is output
   DTC B009E-83 is not output

Result: 

DTC B009E-83 is not output 

USE SIMULATION METHOD TO CHECK. Refer to  HOW TO PROCEED WITH TROUBLESHOOTING [07/2020 - ] 

Result: 

DTC B009E-83 is output 

See step  2

1. Turn the ignition switch off.
2. Disconnect the cable from the negative (-) auxiliary battery terminal, and wait for at least 60 seconds.
3. Check that the connectors are properly connected to the side No. 2 airbag sensor assembly RH and side airbag pressure sensor RH.

   OK

   The connectors are properly connected.

   Result

   Proceed to
   OK
   NG

Result: 

NG 

CONNECT CONNECTORS PROPERLY 

Result: 

OK 

See step  3

1. Interchange the side airbag pressure sensor RH with LH and connect the connectors to them.

   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

   *1	Side Airbag Pressure Sensor LH
   *2	Side No. 2 Airbag Sensor Assembly RH
   *3	Wire Harness

2. Connect the cable to the negative (-) auxiliary battery terminal, and wait for at least 2 seconds.
3. Turn the ignition switch to ON, and wait for at least 60 seconds.
4. Clear the DTCs stored in memory.

   Body Electrical > SRS Airbag > Clear DTCs 

5. Turn the ignition switch off.
6. Turn the ignition switch to ON, and wait for at least 60 seconds.
7. Check for DTCs.

   Body Electrical > SRS Airbag > Trouble Codes 

   Result

   Proceed to
   DTC B009E-83 is output
   DTC B009B-83 is output

   HINT: 

   Codes other than DTCs B009B-83 and B009E-83 may be output at this time, but they are not related to this check.

8. Turn the ignition switch off.
9. Disconnect the cable from the negative (-) auxiliary battery terminal, and wait for at least 60 seconds.
10. Return the side airbag pressure sensor LH and RH to their original positions and connect the connectors to them.

Result: 

DTC B009E-83 is output 

REPLACE AIRBAG SENSOR ASSEMBLY. Refer to  REMOVAL [07/2020 - 10/2022] 

Result: 

DTC B009B-83 is output 

REPLACE SIDE AIRBAG PRESSURE SENSOR RH. Refer to  REMOVAL [07/2020 - 10/2022]