LEMON Manuals: Even more car manuals for everyone
Home >> Toyota >> 2021 >> Venza LE >> Repair and Diagnosis >> Brakes >> Mechanical - Hydraulic >> Electronically Controlled Brake System - Diagnostic Codes (1 Of 5) >> Electronically Controlled Brake System >> Inspection [07/2020 - ] >> Procedure

Inspection [07/2020 - ]: Procedure

  1. INSPECT VSC OFF SWITCH 
    1. Measure the resistance according to the value(s) in the table below.
      GTY974296Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
      *a Component without harness connected
      (VSC OFF Switch)

      Standard Resistance

      Tester Connection Condition Specified Condition
      5 (+) - 2 (E) Switch pushed Below 1 Ω
      5 (+) - 2 (E) Switch not pushed 10 kΩ or higher
  2. INSPECT BRAKE HOLD SWITCH (ELECTRIC PARKING BRAKE SWITCH ASSEMBLY) 
    1. Measure the resistance according to the value(s) in the table below.
      GTY972894Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
      *a Component without harness connected
      (Brake Hold Switch (Electric Parking Brake Switch Assembly))

      Standard Resistance

      Tester Connection Condition Specified Condition
      10 (+B) - 12 (E) Switch pushed Below 50 Ω
      10 (+B) - 12 (E) Switch not pushed 10 kΩ or higher
scientia non olet · About LEMON Manuals