Caution / Notice / Hint
The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are removed and installed, or replaced during windshield outside moulding removal/installation are shown below.
| Replaced Part or Performed Procedure | Necessary Procedure | Effect/Inoperative Function when Necessary Procedure not Performed | Link |
|---|---|---|---|
| Windshield glass* | Adjust forward recognition camera |
|
One Time Recognition: Refer to ADJUSTMENT (ONE TIME RECOGNITION) [07/2020 - 10/2022] or Sequential Recognition: Refer to ADJUSTMENT (SEQUENTIAL RECOGNITION) [07/2020 - 10/2022] |
*: Even when not replacing the part, it is necessary to perform the specified necessary procedures after installation.
When replacing the windshield glass of a vehicle equipped with a forward recognition camera, make sure to use a Toyota genuine part. If a non-Toyota genuine part is used, the forward recognition camera may not be able to be installed due to a missing bracket. Also, the dynamic radar cruise control system, front camera system, lane tracing assist system, road sign assist system, pre-collision system or automatic high beam system may not operate properly due to a difference in the transmissivity or black ceramic border.
HINT:
- Use the same procedure for the RH side and LH side.
- The following procedure is for the LH side.