LEMON Manuals: Even more car manuals for everyone
Home >> Toyota >> 2021 >> Venza LE >> Repair and Diagnosis >> Body & Frame >> Exterior Body Panels >> Exterior Panels / Trim - Service Information (1 Of 2) >> Roof Rack >> Reassembly [07/2020 - ] >> Procedure

Reassembly [07/2020 - ]: Procedure

  1. INSTALL NO. 3 ROOF CARRIER SEAL 
    1. For Front Side:
      1. Temporary install 2 new No. 3 roof carrier seals.
        GTY1013940Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
      2. Install the 2 nuts.
        GTY1013950Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

        Torque: 26 N*m (265 kgf*cm, 19 ft.*lbf) 

        NOTE:
        • When using a vise, place aluminum plates between the part and vise.
        • When using a vise, do not over tighten it.
    2. For Rear Side:
      1. Temporary install 2 new No. 3 roof carrier seals.
        GTY1013921Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
      2. Install the 2 nuts.
        GTY1013930Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

        Torque: 26 N*m (265 kgf*cm, 19 ft.*lbf) 

        NOTE:
        • When using a vise, place aluminum plates between the part and vise.
        • When using a vise, do not over tighten it.
scientia non olet · About LEMON Manuals